Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > fw cd-rw, zip disk, internal cdr not mounting in jaguar

fw cd-rw, zip disk, internal cdr not mounting in jaguar
Thread Tools
kreamac
Fresh-Faced Recruit
Join Date: Oct 2002
Status: Offline
Reply With Quote
Oct 27, 2002, 12:11 PM
 
Hello everybody
I'm a bit puzzled. My lacie firewire cdrw (40-12-48) and the int. cdr (Samsung)
and int. Iomega zip disk doesn't mount in jaguar (10.2.1) on a G4 500 agp. However they are all recognized in the systemprofiler. Sometimes if I load the drives before booting up, they will mount, until I eject the media. If I reload any of the drives they will not mount.
Sometimes I can eject media from toast, even though it says "no disk"
They mount ok in 9.2.2, also did in 10.1.5, before the upgrade. (formatted HD, OSX 2, clean install, all updates run)
I have updated all firmware, repaired permissions, even reformatted and reinstalled the os, repaired permissions again.
I have tried to unplug and hotplug the FW unit, all to no avail
Any suggestions would be greatly appreciated.
Thanks
kreamac, new member
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 06:48 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2