Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > RIP Issue

RIP Issue
Thread Tools
Brian24
Fresh-Faced Recruit
Join Date: Nov 2002
Status: Offline
Reply With Quote
Nov 19, 2002, 07:13 AM
 
I am trying to get set up to a Canon CLC 1150 with a ColorPASS M-25 RIP attached to it. My Network Admin says he does not want to run AppleTalk cause it creates idle chit chat on the network. However, I cannot seem to get set up to it through IP. I have the driver, the printer pings on the network and I have tried both the default queue and a few know/defined queues as well. I can see very other printer on my network, including a Océ 3165, HP 2100, and a HP 2500CP and print to them with no problems. Does anybody have any ideas, I am all tapped out and the Canon site is severly lacking in information on this device. Any ideas would be greatly appreciated.
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 11:22 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2