Palm USB Cradle power supply

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Palm USB Cradle power supply

Thilo Ettelt Senior User Join Date: Jan 2002 Location: City of Beck's beer Status: Offline	Jun 19, 2003, 01:24 PM
	Hi, i've got a Palm m125 with a USB cradle, i recently found out the ability to connect it with a power supply in order to charge the batteries. There's this plug on the cradle, but what voltage/amperes do i need? (i have a standard power supply, i can set it to different voltages, the manual says the consumer should not exceed a specific value 0,3A at PA 300, 0,4A at PA 400, etc -- i have no clue what that means exactly tho). So what do I have to care about exactly? - Thilo