Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Burning ends in Error Code 14035

Burning ends in Error Code 14035
Thread Tools
JMT
Guest
Status:
Reply With Quote
May 24, 2001, 03:27 PM
 
Anybody know what this error code is or where I could find out what it means?

I get "internal error" message and the above error code with some burning sessions with Disc Burner. The error occurs just before the actual burning should start and the disc is ejected. The amount of data I tried to burn was little over 500 MB so it should fit on one CD. Note that the discs were OK and apparently "untouched" since I could use them later without any problems. Note also, that in the end I could burn the data after dividing it in two parts and burning it on two CDs. I'm using LaCie's Pocket FireWire CDRW.
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 01:37 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2