Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Deskjet 930c drivers

Deskjet 930c drivers
Thread Tools
willed
Professional Poster
Join Date: Oct 2000
Location: London
Status: Offline
Reply With Quote
Jun 7, 2002, 06:57 AM
 
My printer works with OSX, but only just. It prints really slowly. Any ideas why? I think it's probably the driver. The latest version of the driver on the HP site is 1.3. How do I find out if the one I've got is earlier?

Thanks,

Will
Will Edwards
     
joe
Grizzled Veteran
Join Date: May 2000
Location: northeast PA
Status: Offline
Reply With Quote
Jun 8, 2002, 07:17 AM
 
I also own an HP930. I'm running v1.3 of the drivers in 10.1.5 on a G4 Cube. You might want to experiment with the print settings. The 1st time I installed the OSX HP drivers (v1.1 iirc) I noticed that unlike in OS9, the Normal setting was highest quality which uses that slow microline feed. I changed the settings a few times between Draft and Normal and it eventually reset. Not sure what caused that - anyway, that was quite a while ago. It's been fine ever since........joe
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 07:23 AM.
All contents of these forums © 1995-2009 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.4 © 2000-2009, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2