If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
I recently installed a 75GB IBM Deskstar drive into my G4/500 and upon running the Drive Setup I am able to initialize it but it only shows about 32GB as the drive size - not the full 75GB. Do I need some firmware possibly as this could be an ATA/66 and ATA/100 conflict?
I am confused as to why this doesn't recognize the entire 75GB.
Your jumper settings on the drive are not set correctly. Refer to the IBM web site, or your instructions that came with the drive, (if there were any), for the proper settings for the jumpers.
Top
