Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Monitor Dying? OS 9.1 helping?

Monitor Dying? OS 9.1 helping?
Thread Tools
graphics84
Senior User
Join Date: Jun 2000
Location: san diego
Status: Offline
Reply With Quote
Jan 15, 2001, 08:31 PM
 
running a NEC MultiSync XE21 on a G3 450 with a Rage 128 pro (16mb)

I just installed OS 9.1 and Now the two highest resolutions are 1024X768 @ 75Hz and 1280 X 1024 @ 60hz (there where better options before)

this is using "Monitor Control Panel" via the OS 9.1

I have a second Monitor running off an ATI VR 4MB card... it has a lot of resolutions and can go much higher... the monitor connected is a NEC MultiSync A700

Now the 21" is now set at 1024 X 768 @75hz... and I see a dark spot in the lower left corner. There was a speaker there but it's an Altec Lansing shielded speaker... last but not least; I can see the refresh even at 75Hz!

is my monitor going bad or is it 9.1? is this all just a big coincidence?
www.angryf.com
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 04:02 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2