Adaptec 39160 Board & OS X

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Adaptec 39160 Board & OS X

festoons Fresh-Faced Recruit Join Date: Jan 2001 Location: Pittsburgh, PA, USA Status: Offline	May 8, 2001, 07:02 PM
	Ok, here is the deal. I went to adaptec's site and looked for the OS X drivers and found that they were in beta. I downloaded them and stuffit expanded them as it should and mounted the .img. I then began to mount the disk image which also went well. But then I tried to open the readmes and the installer file and it couldn't open the damn thing. Someone else know why?