Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Atto UW SCSI Card - need to boot G4

Atto UW SCSI Card - need to boot G4
Thread Tools
Fin
Fresh-Faced Recruit
Join Date: Jan 2001
Status: Offline
Reply With Quote
Jan 27, 2001, 07:56 PM
 
Hi

I am trying to get an ATTO UW SCSI card pulled from a G3 MT to boot up an UW SCSI drive in my G4 - I assumed as it was installed by apple in the G3 as the primary drive controller that the firmware would let me do this - it doesn't! - any advice? - is there a firmware update that will let me do this?

I'd really appreciate some help on this.

..
Fin
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 04:17 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2