Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > ide-firewire bridge

ide-firewire bridge
Thread Tools
BenDover
Fresh-Faced Recruit
Join Date: Aug 2001
Status: Offline
Reply With Quote
Nov 17, 2001, 04:29 AM
 
Is it possible to attache a master and a slave device to one ide-firewire bridge?
     
Borborygmi
Registered User
Join Date: Mar 2001
Location: Adelaide, South Australia
Status: Offline
Reply With Quote
Nov 17, 2001, 07:32 AM
 
Most of the older chipsets do not support this, but some of the new Oxford 911 chips do. Check out the boards from Granite Digital... they definitely support 2 devices per board.
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 07:51 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2