[KatmanDu]

When I converted to Mac a few weeks ago (24" C2D iMac), I took the Huey with me. Updated to the latest Mac version, installed software, plugged it in, and all was fine. Except... after the initial calibration, the software can no longer find the sensor. If I uninstall the software and reinstall it, the sensor's back; but once I shut the machine down and start up again and run the calibration, it tells me "Sensor not found". The Huey is plugged straight into one of the USB ports on the back, not through a hub. Any ideas?

[KatmanDu]

Well. I wrote Pantone asking the same question, and one of their techs said they had heard of this problem before and were working on it. He suggested unplugging and plugging in the Huey. I scoffed to myself- surely I'd tried such a simple solution already... hadn't I? Unplugged it and plugged it back in and... it worked. Well. He said it may have to be done after each re-boot until they figure out the problem.