Help with "dead" scsi hardrive

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > Help with "dead" scsi hardrive

productionmonkey Fresh-Faced Recruit Join Date: May 2001 Location: mississauga, ontario, canada Status: Offline	May 22, 2001, 11:58 AM
	I have an IBM SCSI drive attached via a 2940 Card internally to my G4. I had unplugged the ribbon and then replugged it in, (or tried to, as I tried to plug the ribbon in upside down- most obviously the root of the problem D'oh!) and the drive won't mount (I figure it's toast due to voltage etc) and although Disk First Aid sees it, it won't properly format it. Should I pitch it or is there some how I can ressurect this drive? It formats until the end of Drive Setup etc but it won't completely format. Help!