If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
I have Macos 8.5.1, and seeded QT4 beta on my cpu, and now the control strip is gone. When I try to activate the control panel, I get a "could not start up the Control Strip" error. Anybody else have this problem? Love, Ovid
------------------
:<
Jack Mello
Guest
Status:
Apr 20, 1999, 09:14 PM
Do you have the "ATI Desktop Video" Control Strip module installed? It is part of the standard software install with the AATI XclaimVR card. It appears that if it's installed neither Apple's Control Strip nor Extensions Strip Control will launch.
I have had problems with the "ATI Desktop Video" Control Strip module with certain configurations under QT 3; so I suspect the problem is with the "ATI Desktop Video" CSM and not QT 4.
[This message has been edited by Jack Mello (edited 04-21-99).]
Petemaz
Guest
Status:
Apr 21, 1999, 11:27 AM
Same Problem with the control strip, only with QT4 though...
Yanqui
Guest
Status:
Apr 21, 1999, 01:07 PM
After installing QT4 I had a crash in the control strip. ES pulled it out of the debugger, but the CS didn't show up. I do have the ATI CS module installed. Will have to try disabling that & see what happens.
oviw
Guest
Status:
Apr 21, 1999, 07:04 PM
The ATI Desktop video extension CSM does indeed conflict with QT4 beta..possibly from the updated QT extension?..Who knows..Thanks and shout out to Jack Mello :<)
[This message has been edited by oviw (edited 04-21-99).]
n8jones
Guest
Status:
Apr 23, 1999, 06:05 AM
Just to add my 2 cents - I had the CS disappear too when I installed QT4. It may be a combination of that ATI extension and QT4, but I resolved it by uninstalling QT4 and going back to version 3.
(I'm running OS 8.5 by the way)
[This message has been edited by n8jones (edited 04-23-99).]
Top
