Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Enthusiast Zone > Classic Macs and Mac OS > Start-up Problem

Start-up Problem
Thread Tools
Dedicated MacNNer
Join Date: Mar 2000
Location: Los Angeles, CA
Status: Offline
Reply With Quote
Jan 14, 2001, 11:30 AM
 
I have a start up problem since I updated to 9.1

When I press once on the start button on the computer, the computer starts but nothing happens. I need to press the reset button and then it starts to work.

I have a G4 400. This problem did happen before but it was really unusual. However, since I updated to 9.1, it is all the times.

Does any one have this problem or know how to fix it?

Thanks

Dopik
I am a Compulsive Software Update Button Clicker
     
Junior Member
Join Date: Mar 2000
Location: St. Cloud, Florida
Status: Offline
Reply With Quote
Jan 14, 2001, 01:42 PM
 
Um, if you problem is the same one that I have, you need to see if you have two different speed memory modules.

In my case, I had a 64MB 3-2-2 module and a 128MB 2-2-2 module. I pulled the 64MB module and my 450MHz DP G4 works like new.

(I didn't figure out this solution, I read about it somwhere in these forums...)

--Tom
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -4. The time now is 08:31 AM.
All contents of these forums © 1995-2015 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2015, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2