Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Enthusiast Zone > Classic Macs and Mac OS > PLEASE HELP WITH VIRTUAL PC AND AUTOCAD

Thread Tools
Fresh-Faced Recruit
Join Date: May 2001
Status: Offline
Reply With Quote
Jul 24, 2001, 01:28 PM
I'm considering buying a new mac 867, but I have to run autocad 2000 for 2d work. Is there anyone out there that uses virtual pc4 on a g4 to run autocad? What are your thoughts. Please help, as I may be forced into buying a pc

Addicted to MacNN
Join Date: Dec 2000
Location: New York City
Status: Offline
Reply With Quote
Jul 24, 2001, 03:38 PM
The short answer is: it depends.

I run AutoCad r.14 via VPC 4.02 on a 500Mhz Pismo. I work with AutoCad in an external monitor, and I live with the slight pauses in the screen refresh rate. VPC only emulates 4MB of video ram, so this may be the problem. I don't know how it would stack up with the GeForce video cards in an 867.

I don't know much about r.2000. AutoCad will work, but the real question is will it work for you.

You can also try this discussion.

Good luck,

Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Privacy Policy
All times are GMT -4. The time now is 03:17 AM.
All contents of these forums © 1995-2015 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2015, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2