If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
i have some IBM 0664-N1H 2GB hard drives.. they are 68 pin.. i recently purchased a 68 to 50 pin converter without termination.. the drives don't show up on my computer or on a friend's 8500.. do these drives need a 68 pin terminator of some sort? any help is appreciated.
Jul 13, 2000, 11:59 AM
What SCSI type is the drive in question (eg SCSI-2, Wide, Ultra-Wide etc)? Does your machine or SCSI card able to run this type of drive??
Jul 13, 2000, 12:27 PM
They will need termination but you should be able to do this with jumpers on the drive. Also make sure you have unique ID #'s You can usually look up the jumper settings at IBM's website
Jul 14, 2000, 02:01 AM
the drive is SCSI-2 but doesn't have any on-board terminaton to my knowledge... i know that the data lines that aren't used by 50 pin scsi need to be terminated but will i need a pass-through terminator to do this?
[This message has been edited by funkymonkey (edited 07-14-2000).]