Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Mac Desktops > imac 500 screen sharpness

imac 500 screen sharpness
Thread Tools
cat-n-the-hat
Fresh-Faced Recruit
Join Date: Mar 2003
Status: Offline
Reply With Quote
Mar 24, 2003, 05:04 PM
 
I just got a 500 mhz imac and comparing the screen to my older 266 imac screen it is not quite as sharp. Is there an adjustment that I can do? I had it apart upgrading the hard drive and I noticed to adjustment dials on the side(analog board) when I had my bottom case off. Can anyone tell me how to adjust to get a sharper picture.

Thanks
Cat-n-the-hat
     
TazmanDman
Junior Member
Join Date: Aug 2000
Location: Haltom City, TX
Status: Offline
Reply With Quote
Mar 27, 2003, 04:59 PM
 
the top dial on the analog board is for focus, the bottom dial is for cutoff/ contrast.

be extremely careful with the contrast, if its up too high the CRT will just shut down and you'll have to reboot for the electrons to start shooting again.

good luck

- Taz
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 09:55 PM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2