[l008com]

The Infamous.... Power Switch Problem. I've done some searches and from what I can tell, I can reset the PRAM, update the firmware, and replace the rubber gasket on the power switch. I'm wondering if anyone can add to this? I've haven't dealt with many cubes.

[chris v]

There's also the infamous place-a-scrap-of-paper-betweeen-the-swich-and-the-housing trick. Not absolutely sure how it's done, as I've never had to do it, but check around here. i've seen it crop up before.

edit: Here's a thread with explicit instructions.

Just don't start expecting me to do all your work for you.

CV

[jonasmac]

It's as simple as placing a piece of paper between the casing and the actual switch. If I can manage it, ANYbody can.

check out: www.cubeowner.com

These cube enthusiasts are EXTREMELY helpful.

--jonas