Startup Disk cannot see pci drive

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Mac Desktops > Startup Disk cannot see pci drive

mhhack Fresh-Faced Recruit Join Date: Feb 2006 Status: Offline	Feb 25, 2006, 09:55 AM
	Hi - I'm using a Powermac G3 (BW) with a hard drive attached to a ata100 pci card which is running 10.3.9. I also have installed on the native hard drive 9.2 and 10.4. The startup disk is the pci, from which I can see 9.2 and 10.4 in disk startup. When I choose to run 10.4 it boots perfectly - however. when I want to return to 10.3.9 disk startup fails to see the pci drive, but does see 9.2. If I then boot to 9.2, I can again see 10.3.9 and 10.4. Anyone have any idea why Tiger on the native drive cannot see the pci drive? Thanks