[ulmer]

I'm trying to find out if the Al 15" is going to fit on my laptop stand. The Ti 15" is pretty close to being too big currently. I can't find a picture of the bottom anywhere I've looked.

So, if you're bored on a Saturday afternoon. The distance from the little rubber feet, both side to side and front to back, and/or a picture of the bottom of the machine would be greatly appreciated.

Thanks!

-Brian

[KP*]

OK, I'm going to attempt to draw this. Imagine the O's are the feet. The fourth side was difficult to draw, but the main dimensions are 12.5" wide and 8 3/8 deep (to the nearest 1/16" and rounded down to be conservative).

O---------------12.5"-------------O
-
-
-
8 3/8"
-
-
-
O---------------12.5"-------------O

I measured the distance in between the two feet, so it's the actual clearance you have between feet. Hope it fits on your stand.

[ulmer]

Great, that's actually a little less than the Ti in both directions. It'll work. Thanks!!