Broken trackpad connector

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Mac Notebooks > Broken trackpad connector

jefferph Fresh-Faced Recruit Join Date: Mar 2006 Location: Coventry, UK. Status: Offline	Mar 1, 2006, 04:36 PM
	Hi everyone, I was just finishing replacing the reed switch/inverter cable on my iBook G3 600MHz and as I was lifting up the trackpad connector "bar" to put the trackpad ribbon in, it came off in my hand . As you can imagine, I'm a bit annoyed at this. I was just wondering if anyone had any experience in soldering such components back onto the logic board, do you think it's possible? Here's hoping... Paul.