G3 B&W power supply in a G4 AGP ??

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Hardware Hacking > G3 B&W power supply in a G4 AGP ??

ken310 Fresh-Faced Recruit Join Date: Nov 2002 Location: Crystal Coast NC Status: Offline	Feb 28, 2003, 06:47 PM
	I pulled a power supply from a G3 B&W and with the exception or 2 posts it looks identical to my G4 AGP. When I installed it it worked great. I could have switched the two wires but a schematic of them showed equal voltage so I didn't bother. This is a reference site but it (for some reason) doesn't show the different wires? The ones that are different are the ones on the end that are orange and orange and brown. Yes the G4 is a Sawtooth board. Ideas ?? http://docs.info.apple.com/article.h...onID=anonymous\|164901211