933 QS in a 533 DA board

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Hardware Hacking > 933 QS in a 533 DA board

ed374 Fresh-Faced Recruit Join Date: Aug 2003 Location: Orange County, CA Status: Offline	Apr 13, 2005, 07:40 PM
	ive been driving myself crazy trying to install a 933QS processor into a DA 533. i have found some teasers telling me to ground the 4th extra mounting hole wih 12V from the Powersupply.....i get no dice....the computer will no longer power up....the light turns on then off....as if a kill switch just happened... what i did was install the procesor card, heatsink....rigged a nut and screw and ran LONG extra MOLEX yellow lead witha pigtail fitting from my extra connectors in the case.... CAN ANYONE HELP....i want to get this to work...any suggestions, please!