If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
These work:
Power Mac G4 (AGP Graphics)
Power Mac G4 (PCI Graphics)
Macintosh G4 Server (except Gigabit Ethernet models)
Power Macintosh G3
Macintosh G3 Server
Power Macintosh G3 All-In-One
These don't:
Power Mac G4 Cube
Power Mac G4 (Gigabit Ethernet)
iMac
PowerBook G3
Minimum req'd:
64 MB of RAM.
1 GB hard disk.
hope this helps.
also, the page with support for server1.2 on the apple site is linked from the very bottom of the support page for server10. there you can find lots of info.
thanks
i did have it installed on my imac though, unsupported, but it worked fine
i was just wantin to try to install it onto my old powercomputing mac upgraded with a 604/180 card
but it wont install onto it, even unsupported
Originally posted by smic:
<STRONG>thanks
i did have it installed on my imac though, unsupported, but it worked fine
i was just wantin to try to install it onto my old powercomputing mac upgraded with a 604/180 card
but it wont install onto it, even unsupported</STRONG>
FWIW: 1.2 installed (and ran) just fine on my PowerMac 7500 (with a 200MHz upgrade card). 64MB RAM.
Top
