working with mono/c# in 10.4

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Software - Troubleshooting and Discussion > Mac OS X > working with mono/c# in 10.4

horix Fresh-Faced Recruit Join Date: Oct 2003 Status: Offline	May 19, 2005, 10:29 PM
	just upgraded to tiger... installed the dev tools and fink.. want to run mono and develop with gtk# have mono working, went to set up gtk# per the instructions on this site: http://www.mono-project.com/Mono:OSX...n_MacOS_X_10.3 tried to install gnome and got some perl dependancy issues... i have the fink system perl package (the virtual package) and so i went to install perl586 within fink and got errors there when it tried to make (exit code 2) any ideas here?
	horix PBG4 12"/867Mhz/40GB/640MB - 10.3.5