Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Enthusiast Zone > Networking > Direct Mac-to-Mac network

Direct Mac-to-Mac network
Thread Tools
Fresh-Faced Recruit
Join Date: Aug 2000
Status: Offline
Reply With Quote
Jan 10, 2003, 09:56 PM
Hello. I have 2 Macintoshes. A G3 Powerbook Wallstreet and a Beige G3.

They both have got a brand new system installed, OS 9 upgraded to OS 9.1, OS 9.2.1 and finally OS 9.2.2

I want to connect the two computers and have bought a "Crosswired Ethernet Cable".

I also have a 56k modem in the Powerbook that I use to connect to the internet.

In AppleTalk and TCP/IP control panel I am unsure what to do.

AppleTalk will not switch to Ethernet. When I try, it says "an error occured during the attempt to use Ethernet. Check network connections" and when I click OK, it swisthes automatically back the the setting it had (modem port or printer port).

I am also in doubt if I can use both modem and ethernet at the same time.
How shall I set up Appletalk and TCP/IP?

Thank you in advance

Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Privacy Policy
All times are GMT -4. The time now is 07:06 PM.
All contents of these forums © 1995-2015 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2015, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2