Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Enthusiast Zone > Networking > Using a Buffalo repeater with Airport Extrem

Using a Buffalo repeater with Airport Extrem
Thread Tools
applescriptguru
Registered User
Join Date: Jun 2006
Status: Offline
Reply With Quote
Apr 2, 2006, 03:19 PM
 
I have a Ibook(10.4) with airort card interfaced with airport extreme. Imac is located upstairs(10.3)
Imac does not have airport card but when interfaced directly with extreme and trying to use ibook downstairs I do not have enough signal strength.
I purchased a Buffalo WKA2G54 repeater bridge to hook to imac and then join same single network as ibook.
Buffalo info on the web is sketchy at best. I have not been able to set up the repeater to join the network. Could use some help in setup procedure for Buffalo on imac and subsequently the airport extreme settings on ibook..
Thank you
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -5. The time now is 06:11 AM.
All contents of these forums © 1995-2011 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.7 © 2000-2011, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2