Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Enthusiast Zone > Networking > Add airport express to xfinity wireless modem

Add airport express to xfinity wireless modem
Thread Tools
Addicted to MacNN
Join Date: Jul 2001
Location: I don't know anymore!
Status: Offline
Reply With Quote
Aug 6, 2013, 11:40 PM
 
I just got a new Xfinity (Comcast) wireless modem. Before I had a hardwired Motorola Surboard modem, and an Airport Express, to get my house wireless. However, the range wasn't what I expected. Now that I have a wireless modem, is there a way to add the Airport Express, a little closer to the other end of the house, to get more range? I launched Airport Utility, but it doesn't find the Express. Thanks for any help.
Why is there always money for war, but none for education?
     
Mac Elite
Join Date: Jun 2006
Location: Pittsburgh
Status: Offline
Reply With Quote
Aug 7, 2013, 09:15 AM
 
is the Airport Express able to be wired into the LAN? or are you trying to extend the signal wirelessly?
     
Addicted to MacNN
Join Date: Jul 2001
Location: I don't know anymore!
Status: Offline
Reply With Quote
Aug 7, 2013, 10:05 AM
 
I'd like to able to extend the signal wirelessly. My old Motorola wired modem died, so Comcast sent me a new wireless one, but I still have the Express, and I'd like to extend the wireless signal.
Why is there always money for war, but none for education?
     
Mac Elite
Join Date: Jun 2006
Location: Pittsburgh
Status: Offline
Reply With Quote
Aug 7, 2013, 10:20 AM
 
Extending a wireless signal is not the most preferred option, but it can work. There is a chance the mix of models could be an issue and what you are essentially doing is attempting to extend an already weak signal, but let us persist.

You'll need to reset the Airport Express to factory settings and attach it to your Mac via ethernet. Open Airport Utility and you should see it listed.

Highlight it and click Manual Setup. The Summary tab will be viewable: switch to Internet. Select Extend a wireless network from Wireless Mode. Select your Encryption of your combo modem and enter your Wifi password. WPA2 Personal is recommended unless you really need WPA for legacy devices; I have the best results with multiple APs if they are set to only WPA2 Personal. On your combo modem, check to see what your encryption settings are. WPA2+AES encryption is what you want.

Under Base Station tab, you can set base station name and configuration password if you desire. With the Wireless Mode changed to Extend a Wireless Network and with the proper credentials/encryption entered, click Update. the Airport Express will restart and apply the new settings. The light will be orange throughout this process. Give it a few minutes and with any luck, the light will turn green and the Express will be extending the Wifi network.

Sidenote: I am using Airport Utility 5.6- the newer one included in Lion/ML is a bit hampered. you can download 5.6 here
( Last edited by abbaZaba; Aug 7, 2013 at 10:33 AM. )
     
Addicted to MacNN
Join Date: Jul 2001
Location: I don't know anymore!
Status: Offline
Reply With Quote
Aug 7, 2013, 11:03 AM
 
I think this may be an exercise in futility. The green light is on the Express, but the range doesn't seem to be increased. In Airport Utility, the Express shows up, but it says the device is not found, even though the light is green on the Express.
Why is there always money for war, but none for education?
     
Clinically Insane
Join Date: Jun 2001
Location: planning a comeback !
Status: Offline
Reply With Quote
Aug 7, 2013, 11:18 AM
 
Does the Comcast wireless modem have an ethernet port ?

You can always go "low tech".
Get two ethernet-over-powerline adapter, connect one to the Comcast modem, and the other one in the remote room to the Airport Expresss.

-t
     
Addicted to MacNN
Join Date: Jul 2001
Location: I don't know anymore!
Status: Offline
Reply With Quote
Aug 7, 2013, 11:23 AM
 
I'll try the Ethernet over power line adaptors. As I mentioned, the green light on the express is lit, about 30 feet from the Comcast wireless modem, but I only get full bar signal a couple of feet on either side of the Express, and it still says, in Airport Utility, that the Express isn't found.

I also downloaded the 5.6 Utility, but it won't let me install it on my Mountain Lion iMac.

Thanks, both of you, for your help!
Why is there always money for war, but none for education?
     
Mac Elite
Join Date: Jun 2006
Location: Pittsburgh
Status: Offline
Reply With Quote
Aug 7, 2013, 12:38 PM
 
turtle's beat me to my next suggestion.

I have used powerline to attach APs to a wireless network. it works well. last I checked there were some ActionTec's 500Mbps on Amazon for $42. the ports are limited to 100base ethernet so the AP attached via powerline will max out at 100base speeds, but this won't be a huge limiting factor.

going this route, instead of selecting Extend a wireless Network, you want to Create a Wireless network. the SSID, Password, and encryption all need to be the same as the one created on the combo modem.

The other setting you will need to adjust is under the Internet icon: Under Internet Connection->Connection Sharing turn to Off (Bridged Mode). This will disable the DHCP and NAT as the combo modem is handling these services.

Update the settings and attach the Express to the end of the powerline chain and you should be good to go. The Express will choose the wifi radios' channels automatically and these can be manually adjusted to avoid interference but we can address that once you have everything setup.

Edit: powerline kit I recently used: http://www.amazon.com/computers-acce.../dp/B00871SR68
     
Mac Elite
Join Date: Jun 2006
Location: Pittsburgh
Status: Offline
Reply With Quote
Aug 7, 2013, 12:43 PM
 
The link I posted for the 5.6 Airport Utility is actually an install package and will refuse to install on ML- you can go through some steps to extract it but I could throw my 5.6 copy on a host if you want to grab it quickly. The application itself runs fine in ML, it is the install package that i the problem.
     
Clinically Insane
Join Date: Jun 2001
Location: planning a comeback !
Status: Offline
Reply With Quote
Aug 7, 2013, 02:05 PM
 
Use Pacifist to extract the app from the installer file.

-t
     
Addicted to MacNN
Join Date: Mar 2004
Location: UK
Status: Offline
Reply With Quote
Aug 8, 2013, 04:25 AM
 
In my experience, the Airport Express will only extend a wireless network created by another Airport box. Your other option then is to switch off the wifi on the modem and get a second Airport device. Plug one into the modem to create your wireless network and then use the other to extend it. It'll work like a dream.
I have plenty of more important things to do, if only I could bring myself to do them....
     
Mac Elite
Join Date: Jun 2006
Location: Pittsburgh
Status: Offline
Reply With Quote
Aug 8, 2013, 08:56 AM
 
I have had some success with Airport Expresses extending a non-Apple wireless network, but it is flaky. Brand-coherence is really the best setup if you want to extend wirelessly
     
Addicted to MacNN
Join Date: Mar 2004
Location: UK
Status: Offline
Reply With Quote
Aug 8, 2013, 12:20 PM
 
For an extended continuous wireless network, no-one around can beat Apple IMO.

I just installed a second one this week and its so easy and so robust, if you have a big house, you shouldn't bother looking at any other system.
I have plenty of more important things to do, if only I could bring myself to do them....
     
   
Thread Tools
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Top
Privacy Policy
All times are GMT -4. The time now is 12:30 AM.
All contents of these forums © 1995-2014 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2014, Jelsoft Enterprises Ltd., Content Relevant URLs by vBSEO 3.3.2