[nextlevel]

I upgraded to 10.3.9 and after 6 months realized I don't have use of my Agfa Duoscan Scanner anymore. I am using Photoshop CS and would like the fotolook option under import again. I downloaded and installed the drivers but can't get it to show up. Any ideas as to what I'm doing wrong?

Thanks for the help.

[tlooknbill]

Have you checked to see if the Fotolook import plug-in is in PS's Import/Export folder? You may have to go hunting for it on your HD because it may have been installed in the wrong place or not at all.

[nextlevel]

You're right, the plugin is not there. I've downladed the installer three times (i'm a little thick) and I can't locate the plug-in. I can't figure out what I'm doing wrong. I'll look for another download site and try .

Thanks

[nextlevel]

Thanks anyway. This scanner won't work on 10.3 or above. No Wonder.

Thanks

[Alec]

Hello... I have a f40 that is supposed to be compatible with firewire and using 10.3.9 it will work... up and until the calibrating starts.
In reading Agfa'a web site:
"Which version of Mac OS X do I need to run FotoLook 3.6 for Mac OS X?
You need Mac OS X 10.1 or 10.2.1 (not 10.2) or later (till 10.2.8) The startup disk should be HFS+ formatted (NOT UFS). FotoLook 3.6 doesn't work on 10.3 or later."
What is confusing here is that it says FOTOLOOK 3.6 NOT 3.6X!!!!
I am new...so I am not sure what to do!
I will try another vendor. Any ideas?
My thanks...!