|
|
7500 to 8600 Upgrade?
|
|
|
|
Fresh-Faced Recruit
Join Date: Oct 1999
Location: Groton, CT USA
Status:
Offline
|
|
Please excuse me if this has been discussed before.
I have the opportunity to buy a 604e daughter card pulled from an PM 8600. Will it work in my PM 7500? TIA --Glen
|
|
|
|
|
|
|
|
|
The Wolfe
|
|
The 8600 card should physically fit into your 7500, but due to possible electrical differences and/or pin-outs in the card's connectors, it may not actually work.
------------------
Eliott Wolfe
Winnetka, Calif
|
|
|
|
|
|
|
|
|
Dedicated MacNNer
Join Date: May 2000
Location: Chattanooga, TN
Status:
Offline
|
|
Theoretically, it should work. These machines all use the same G3 upgrade cards, so pin outs and electrical requirements should be the same. I haven't actually tried this, however.
|
|
|
|
|
|
|
|
|
Fresh-Faced Recruit
Join Date: Oct 1999
Location: Groton, CT USA
Status:
Offline
|
|
Apparently the card will not work. According to a response from comp.sys.mac.hardware.misc
"No, it won't work. The 8600 and 9600's with the 250 -> 350 MHz daughtercards have Kansas motherboards, which are different than the
Tsunami/TNT motherboards in the 7500/8500/9500". --Mark Heiple
Thought I share this new info with the forum. Thanks Mark and thanks to those who responded --Glen
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Forum Rules
|
|
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
|
HTML code is Off
|
|
|
|
|
|
|
|
|
|
|
|