Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Software - Troubleshooting and Discussion > Applications > IX Micro3d

IX Micro3d
Thread Tools
Mac-Guy
Junior Member
Join Date: Jan 2002
Location: West Michigan Lakeshore
Status: Offline
Reply With Quote
Sep 25, 2002, 03:36 PM
 
I just obtained a G3 300 DT. It has the IXMicro3d card in it. Whenever it starts up, the IXMicro extensions shows up with an X through it. However, I did a reformat and clean install of OS 9.04, which didn't help. The card appears to be working properly, but I'm tired of looking at that dang X. Any hints? (Other than buy a new G4, dude...)
Otis Day?? He loves us!
     
   
 
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Top
Privacy Policy
All times are GMT -4. The time now is 04:19 AM.
All contents of these forums © 1995-2017 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2017, Jelsoft Enterprises Ltd.,