Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Consumer Hardware & Components > USB to IDE bridge

USB to IDE bridge
Thread Tools
cjpainter
Fresh-Faced Recruit
Join Date: Oct 2000
Location: Chandler, Az, USA
Status: Offline
Reply With Quote
Oct 17, 2000, 09:32 AM
 
Has anyone had any experience with putting an IDE CD R/W into a USB External case? The case comes with an extension called USB-IDE Bridge and is supposed to work with any IDE device. I am using a Zip CD R/W which I have used in the internal bay of my G4/400. I was even able to boot from it with thesystem install disk. Any help would be appreciated.

------------------
CJPainter
CJPainter
     
Pasquale
Guest
Status:
Reply With Quote
Oct 17, 2000, 10:31 AM
 
I have read that there can be buffer under-run problems with USB burners, depending on how many USB peripherals you have.
     
   
 
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Top
Privacy Policy
All times are GMT -4. The time now is 06:45 AM.
All contents of these forums © 1995-2017 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2017, Jelsoft Enterprises Ltd.,