Welcome to the MacNN Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

You are here: MacNN Forums > Enthusiast Zone > Networking > Configuring of VLAN's with OS X 10.5

Configuring of VLAN's with OS X 10.5
Thread Tools
carterx
Mac Enthusiast
Join Date: Jan 2007
Location: Canada
Status: Offline
Reply With Quote
Apr 25, 2008, 01:01 PM
 
I upgraded my NetBoot server yesterday from Tiger to Leopard and did it with an erase/install and now with the new OS, I can not seem to get the VLAN's to work. The setting on the switch port are configured and setup the VLAN's similar to how they were with Tiger yet can not get anything. Was very simple in Tiger, just doesn't seem to want to work with Leopard unless I'm doing something wrong.

Any ideas what could have changed from Tiger other than the layout. I know with Tiger, you could drag the VLAN's up and down in the list which would get them to work because some needed to be at the top.
     
carterx  (op)
Mac Enthusiast
Join Date: Jan 2007
Location: Canada
Status: Offline
Reply With Quote
Apr 25, 2008, 01:22 PM
 
Ok, correction, I see how I can change the order of the services, but still no luck. before with Tiger I keep the physical ethernet service at the bottom and then has the VLANS above. Now it will not work no matter the order. Can not ping the VLAn's created from any computer.
     
   
 
Forum Links
Forum Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Top
Privacy Policy
All times are GMT -4. The time now is 06:25 PM.
All contents of these forums © 1995-2017 MacNN. All rights reserved.
Branding + Design: www.gesamtbild.com
vBulletin v.3.8.8 © 2000-2017, Jelsoft Enterprises Ltd.,