If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
Running 8.6 on a 7300. I've got the 10baseT plug in the back of the cpu.
Getting ready to have adsl service installed this week. Low and behold...can't find ethernet in the "config via" box in TCP/IP nor anywhere else on my hard drive.
I have downloaded G3 etherner(built in) 2.0.4 from apple and was going to try just dropping it into my extensions folder but I don't know if this is really what I need nor whether I'll just foul things up further.
Any ideas on what I might do do?