HD won't mount when connected to Ultratek PCI card

	Welcome to the MacNN Forums.
	If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
	You are here: MacNN Forums > Hardware - Troubleshooting and Discussion > Mac Desktops > HD won't mount when connected to Ultratek PCI card

indigo Junior Member Join Date: Aug 2000 Status: Offline	Nov 12, 2001, 10:33 PM
	I've got a Quicksilver G4 running OS 9.2.1. I just added a new hard drive to the computer, so I was going to move the OEM IBM hard drive to a VST Ultratek IDE PCI card I've got installed in the computer. When I did so and rebooted, the OEM drive attached to the PCI card did not mount. I tried to mount it with Drive setup and SCSI probe but could not. Any ideas why the drive would not mount when attached to the PCI card. FWIW, it mounted fine when re-attached to the on board IDE chip. Any ideas about what is going on or how I can get my drive to mount?